When I am calibrating the temp/humidity, and I enter an offset or press the up or down arrow, the offset value shown on the right side does not update unless I leave the page and come back.
Also, I really wish pulse would do something to synchronize sensors to a single calibration, it’s so cumbersome to try to get multiple sensors to agree without refreshing and changing values over and over. It would be nice if we could put all the sensors in a stable place for a while then select a calibration group, then select which devices out of that group should be averaged, then all sensors offset to that average.
I’ve been doing everything I can to modify airflow to get two parts of my room to be the same, turns out half the issue was two sensors that were off by a single degree. I have 5 sensors in a bucket right now and I’ll definitely give up before each one reads the same temp and humidity.
